Owensboro Premium Roofing provides professional fascia & soffit in Owensboro, KY for residential and commercial properties across the Green River region of western Kentucky. Kentucky wrote its own language for exactly one detail in the whole roof-assemblies chapter of its residential code, and that detail is the drip edge at eaves and gables. It is worth knowing what the amendment actually says, because it is more permissive than almost anyone assumes.
The Kentucky section requires drip edge at the eaves and gables of shingle roofs, sets a two-inch minimum lap between pieces, calls for fastening at no more than twelve inches on center, and specifies the sequence that trips up half this trade: underlayment goes over the drip edge at the eaves and under it at the gables. Reversed, water runs behind the metal and straight into the fascia board.
It then allows something genuinely unusual. Site-formed coil stock is accepted, and so is wood, composite or manufactured fascia trim that creates a drip line. So a legal Kentucky roof can be finished at its edge with a trim board rather than with metal, which is perfectly fine while that trim is sound and a slow disaster once it is not.
That is why fascia work and roof work are the same job in this county. On a house built between the 1950s and the 1970s the fascia is usually one-inch nominal pine, it has been wrapped in aluminum at some point in its life, and the wrap has hidden fifteen years of rot from everyone including the last roofer who nailed a gutter through it.
We open the wrap and look, every time, which is the part most crews skip because it turns a tidy morning into a real day. Soft wood gets cut back and replaced with a full-length board rather than a spliced patch, and only then does new metal go on over it. Wrapping over rot turns a four-hundred-dollar repair into a rafter-tail repair inside five years.
Soffit is the other half of the assembly and it is the intake side of your entire attic. Solid boxed cornices with no perforation leave a ridge vent with nothing to draw from, and cutting a continuous vented strip into the underside while the ladders are already up costs very little and changes how the whole roof ages. Doing it later from a ladder costs three times as much and gets done half as well.
Our licensed and insured team brings the right materials and equipment to every job — an ASTM D7158 wind listing read off the manufacturer's data sheet, asphalt cement hand-set beneath every tab laid below fifty degrees, tab-lift bond testing worked along the rake and eave courses, SBS-modified shingle mats specified for low-temperature pliability, a manufactured starter strip carried up both rakes as well as the eaves, perimeter and corner uplift zones marked out on the roof plan — and backs the work with a written workmanship warranty. We serve Owensboro and nearby communities including Henderson, Whitesville, Hawesville, Lewisport.
What We Handle
Everything our fascia & soffit in Owensboro covers
One crew, one point of contact, and the full range of fascia & soffit work in Owensboro, KY. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia and soffit Owensboro
- rotted fascia board replacement
- soffit repair Daviess County
- aluminum fascia wrap
- vented soffit installation
- drip edge Kentucky code
- sub fascia replacement
- boxed cornice repair
- vinyl soffit panels
- woodpecker soffit damage
- fascia rot repair Owensboro
- eave detail repair
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Owensboro services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with an ASTM D7158 wind listing read off the manufacturer's data sheet, asphalt cement hand-set beneath every tab laid below fifty degrees, tab-lift bond testing worked along the rake and eave courses, SBS-modified shingle mats specified for low-temperature pliability, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Owensboro job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the Green River region of western Kentucky means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Owensboro
Owensboro Premium Roofing covers Owensboro and the surrounding communities of the Green River region of western Kentucky. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Henderson, KY — Henderson County, population 27,981
- Fascia & Soffit in Whitesville, KY — Daviess County, population 580
- Fascia & Soffit in Hawesville, KY — Hancock County, population 1,023
- Fascia & Soffit in Lewisport, KY — Hancock County, population 1,767
- Fascia & Soffit in Livermore, KY — McLean County, population 1,230
- Fascia & Soffit in Calhoun, KY — McLean County, population 725
Start on the Owensboro Premium Roofing homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Owensboro Chooses Owensboro Premium Roofing
- ✓We inspect in September and October, before the cool season, because a bond test only means something on a warm deck
- ✓We will tell you to wait until April rather than sell you a December tear-off you do not need
- ✓SBS-modified shingle mats specified for cold-deck flexibility ahead of impact ratings this market does not need
- ✓Six fasteners per shingle on the common bond line, with starter strip carried up both rakes
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Owensboro follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Owensboro gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Owensboro, or request a quote and we'll get right back to you.